Router Init Failed: How to Fix This Altice One Issue
Resetting Altice One will fix the problem right away
3 min. read
Published on
Share this article
Improve this guide
Read our disclosure page to find out how can you help Windows Report sustain the editorial team Read more
Key notes
- To fix the Router init failed error on Altice One, unplug it from the power outlet and leave it for 10 minutes, then plug it back in.
- You may also try to update its firmware or reset it to factory settings.
- The WR networking team has all the detailed solutions below!
If you own an Altice One router, once in a while, you will see the Router init failed message. Fortunately, we have tested it in our WR labs and we have some quick fixes for you.
What does Router init failed mean? Router init failed means that the Altice One router failed to initialize the connection with the network. Another message you may see on the screen is CM registering but that’s not an error. The router is simply rebooting so wait it out.
How do I fix Router Init Failed on Altice One?
Before starting any solutions below, cross-check some prerequisites:
- Verify if there is any damage on the ISP cable that reaches your Altice One router and if it’s firmly connected to the device.
- If this problem occurs often, change the position of the router and place it somewhere where it’s not covered by anything to prevent overheating.
- Disconnect some devices from the router because the Router init failure may also be caused by network congestion.
- Make sure that your ISP plan is active and its services are active. There might be third-party service issues.
1. Restart the router
- Unplug the router from the power and all the connected Ethernet or media cables.
- Wait for at least 10 minutes and plug and reconnect Altice One to the power and devices.
Since there is a miscommunication with the internet service provider, restarting the Altice One cable modem is the best way to fix this router error. After rebooting, usually, everything is restored to normal.
2. Upgrade the router firmware
- While it’s powered on, press the WPS and Diamond buttons at the same time.
- The process will take a few minutes but after that, the router will restart and come back online.
You don’t need to access the router page for this procedure. However, if you can’t access the router page, this article will help you.
3. Use the Network Reset button
- Look at the back of the router and locate the Network Reset button. You will find it next to the USB service port.
- Use a sharp object to press it for 10 seconds. This will reset the Altice One router to normal.
The Router init error may be caused by power outages and if at that moment, the router was updating its firmware, the best solution is to fully reset it.
Unfortunately, after this, you will need to reconfigure Altice One again and reconnect your devices.
If you’re having the same problems with Altice One Mini Box, just press the WPS and Diamond buttons and that will reboot it.
That’s it! Just to sum up, if you see the Router init failed on your Altice One router, try a soft reset first. If that doesn’t fix the problem, try to update its firmware or reset it to factory settings.
If the problem persists, contact your internet service provider about this issue.
You might want to read our article on ways to fix a router that won’t connect to the internet for more information.
For any other questions regarding the Altice One Router init failed issue, feel free to use the comments section below.
